When working on a home improvement project, such as remodeling your vanity lights home depot, you may find that the materials you need to complete the project may not arrive on time. Sometimes, this can delay the installation of the plans, but in some cases, you can install around it. An example is the installation of vanity lights before the vanity itself is installing. Mark the place where the vanity will be installed by breaking a chalk line on the wall to mark each side of the vanity. This allows you to properly position the lighting. Place one foot on the wall between the chalk lines that is as close to being centered between the chalk lines as possible. Keep a circular electrical box against the wall next to the right foot and trace the picture on the wall.
Cut a hole in the wall of the electrical box with a drywall saw. Using a beam detector, locate a beam on the wall where you want to install the light switch. Draw an old-work electrical box on the wall, and cut a hole with the drywall saw. Feed a 12/2 electrical cable between the hole in the wall for the light switch and the main electrical box of your house. And a second wire between the light switch of the hole and the hole for the led vanity lights. A 12/2 cable has two isolated 12-gauge wires and a bare wire. Do not connect the cable to the main box. Drill the blind hole in the back of the circular electrical box (for the toilet). And slide the cable through it. Insert the picture on the wall, and the screw on the bolt.
Drill the end holes in the last work box (corresponding to the light switch), and slide the two electric wires through them. Insert the switch into the hole in the wall, and screw it. Cut a 3-inch long piece of copper cable to spare 12/2 wire. Fold the ends of the black and white wires into the hooks with a pair of pliers. Loosen the terminal screws on the sides of the home depot lighting switch. And hook the black wires onto the bronze colored screws and tighten them. And then connect the white wires to the silver colored screws. Screw one end of the 3-inch ground cable to the ground screw on the bottom of the light switch. And then connect the other end to the ground wires of the wires by rotating them together with a plastic connector cover.